When I arm my unit the alarm goes off with the door in the locked position.


The Arm-A-Dor needs to be reset. The Arm-A-Dor unit is having an issue with one of it's microswitches.

Please reset the Arm-A-Dor unit. There are three microswitches that need to be examined. One under each end cap and one on the sub assembly next to the circuit board. Check and make sure the the end cap microswitches are not broken. Remove the push bar to check the last microswitch next to the circuit board. If the microswitch is good make sure that the switch actuator is properly engaging when the door is in the locked position.


Applies To


Additional Information 
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Limited Warranty on Information: The documents contained on this website are distributed as is, without warranty of any kind, either express or implied, including but not limited to implied warranties for the document’s quality, performance, merchantability, or fitness for any particular purpose. Neither BEST Access Solutions, Inc., nor its dealers or distributors shall be liable to the user or any other person or entity with respect to any liability, loss, nor damage caused or alleged to be caused directly or indirectly by this information.