My Arm-A-Dor is beeping at me twice every few seconds.


Cause: Your unit could possibly been wired incorrectly. Your unit may have been order to have hard wire powere in addition to battery power.

Solution: Disconnect your hard wired power and then pull your batteries. Wait 15 minutes to allow the unit to reset. Plug in the hardwired power then reconnect your batteries. Pull your batteries from the unit. Remove the push bar and locate the circuit board. Set all dip switches to the off postion. Allow your unit to reset then replace push bar.

Applies To


Additional Information 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Limited Warranty on Information: The documents contained on this website are distributed as is, without warranty of any kind, either express or implied, including but not limited to implied warranties for the document’s quality, performance, merchantability, or fitness for any particular purpose. Neither BEST Access Solutions, Inc., nor its dealers or distributors shall be liable to the user or any other person or entity with respect to any liability, loss, nor damage caused or alleged to be caused directly or indirectly by this information.