The BASIS transport application was installed successful but now I’m having problem uploading data into the lock there is an error saying that “Communication error occurred. Reset the device and retry.”


The error is related to the USB to serial cable and the COM port in the BASIS Transport application.

  1. Open the BASIS Transport Application.
  2. Click on the File menu.
  3. Select “Set COM Port”
  4. See what COM ports are available.
     - If none are listed, reboot the netbook.
     - If only one COM port is listed, click on it to place a check mark on it.
     - If more than one is listed, open the device manager and look under Ports (COM & LPT). Locate the USB to Serial Cable and see what COM port is listed. That is the COM port that should check in the BASIS Transport application under Set Port. 
  5. Once the COM port is selected, try again to program the lock.

Applies To

BASIS Transport Version 6

Additional Information


Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Limited Warranty on Information: The documents contained on this website are distributed as is, without warranty of any kind, either express or implied, including but not limited to implied warranties for the document’s quality, performance, merchantability, or fitness for any particular purpose. Neither BEST Access Solutions, Inc., nor its dealers or distributors shall be liable to the user or any other person or entity with respect to any liability, loss, nor damage caused or alleged to be caused directly or indirectly by this information.