How do I create a Wi-Q Manager card in BASIS Wi-Q Interface?

  1. Set up a fake online access panel in BASIS is there are no online Access Panels already created. *This will enable user commands in Access Levels.
  2. Create an Access Level – Manager Permissions
  3. Assign readers and appropriate time zone to the Manager Permission Access Level.
  4. Click on the User Commands tab on the access level.
  5. Place a check in the Command Authority checkbox.
  6. Assign the access level to the user cards that need manager access. 

Applies To

BASIS Wi-Q Interface 3.0.16 and 3.00.17

Additional Information

Please Note If you give manager Permissions to users, they will also have the ability to deep reset a controller.  This is not desirable as your users can accidentally deep reset readers by swiping their cards and then holding down the request to exit.  This needs to be explained thoroughly to those setting up manager permissions and to those who will have it on their cards.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Limited Warranty on Information: The documents contained on this website are distributed as is, without warranty of any kind, either express or implied, including but not limited to implied warranties for the document’s quality, performance, merchantability, or fitness for any particular purpose. Neither BEST Access Solutions, Inc., nor its dealers or distributors shall be liable to the user or any other person or entity with respect to any liability, loss, nor damage caused or alleged to be caused directly or indirectly by this information.