How do I change the track my magstripe or dual validation bezel is reading on?


Remove the reader bezel from the trim, it is held in by 4 screws located behind the electronics board. Once the reader bezel is removed, you will locate the read head (it has 2 red and 1 black wires attached to it). Once located, you will need to remove the read head carrier from the bezel by pulling the read head away from the slot where a card would be swiped (be careful not to let the removable rods fall out of the carrier as your are removing it). Once it has been carefully removed, ensure the green box on the read head is lined up with the correct track number you wish to use (1, 2, or 3)

Applies To

BASIS Offline or WiQ WDC 

Additional Information


Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Limited Warranty on Information: The documents contained on this website are distributed as is, without warranty of any kind, either express or implied, including but not limited to implied warranties for the document’s quality, performance, merchantability, or fitness for any particular purpose. Neither BEST Access Solutions, Inc., nor its dealers or distributors shall be liable to the user or any other person or entity with respect to any liability, loss, nor damage caused or alleged to be caused directly or indirectly by this information.